LOTO - More Than a Lock Part 1

3.0238095238095 1 1 1 1 1 1 1 1 1 1 Rating 3.02 (21 Votes)

Lockout/Tagout is more than just putting a yellow lock on the main electrical disconnect to a machine or part of a machine. There are 7 very important steps you must do when putting Lockout/Tagout in place:

SEVEN STEPS FOR SHUTDOWN

  1. NOTIFY – Notify all affected employees that you are going to be conducting a lockout/tagout.
  2. PREPARE – Before you begin, be sure you know all the types of energy involved, hazards presented by energy, and how to control the energy.
  3. SHUTDOWN – Turn off machine or equipment.
  4. ISOLATE - Isolate machine or equipment from its energy source(s). (For example, turn off main circuit breaker.)
  5. LOCKOUT – apply your lock. Be sure that it holds the isolating device in the “off” or “safe” position.
  6. RELEASE - Release stored energy. Relieve, disconnect, restrain, block, or otherwise ensure, that all energy sources – electrical, mechanical, hydraulic, compressed, etc. – are de-energized.
  7. VERIFY – Try the on-off switch or other controls to be sure the machine won’t start. Return the switch to the “off” position.

YOUR LOCKOUT IS COMPLETE


This toolbox topic was reviewed by ______________________________________ on ___________________________ with the following employees: